|
|
|
Moteck
SG2100 Satellite Dish Motor
|
|
- Do I need a separate power line to connect to
the Moteck SG-2100 Satellite Motor?
No. The motor
gets its power from the receiver using the same coaxial
cable running from the receiver to the LNBF on the dish.
You simply disconnect the cable from the LNBF. Connect it
to the Moteck SG-2100 HH Motor. Then run a short coaxial
cable between the motor and the LNBF. You are set.
- How do I control the motor to move it East / West?
The motor is controlled by the receiver's remote
control. All receivers compliant with the DiSEqC 1.2, 1.3,
or USALS protocol have the capability to run a Moteck SG-2100HH
motor. Once you initially setup the motor on the satellite
arc and store the locations of the satellites, you will
be able to move between satellites by simply changing the
channel.
- Does the motor also adjust for variation in elevation
on the dish for each satellite?
Yes it does.
- Do I need to skew the LNBF on a motorized dish?
No you don't. Just set the skew at 0 and the motor will
tilt the whole dish when it moves.
- What is the benefit from motorizing my dish?
Well, by adding a motor to your system you will be able
to receive satellite channels from several satellites instead
from one only. That way you will gain many more channels
economically without investing in many dishes and switches.
- Where can I find out what channels are available
free to air?
There are many free to air channels
available in North America on satellites such as Galaxy
10R, AMC4, Telstar 5, AMC3, etc. There are channels from
the USA and from around the world. See http://www.lyngsat.com/america.html
for a complete listing of what is available. Anything with
an F designation is FREE TO AIR.
|
|
|
 |
|
|
